| Note I = inspect and clean, adjust, replace or lubricate as necessary. R = replace. T = tighten. |

Lubrication pointsExhaust control system construction
Excv cable no. 1 (Cl)
Excv cable no. 2 (Op)
When
loosening or tightening the pulley bolt, be sure to fix the
pulley with an adjustable wrench, or excva may get damaged.
5 N·m (0.5 Kgf-m, 3.5 Lbf-ft)
42 – 43 Mm (1.65 – 1.69 In)
60 – 61 Mm (2.36 – ...
Clutch adjustment
Clutch cable play should be 1 0 -
15 mm (0.4 - 0.6 In) measured at
the clutch lever end. Adjust clutch
cable play according to the following
procedure:
Minor adjustment
Turn the clutch cable adjuster 1
to provide the specified play.
Major adjustment
Turn in the adjuster 1 all the ...
Stp sensor removal and installation
Removal
Remove the throttle body. Refer to “throttle body
removal and installation” in section 1d (page 1d-
10).
Remove the stp sensor (1) with the special tool.
Special tool
: 09930–11950 (torx wrench (5 mm))
Note
prior to disassembly, mark the stp sensor’s
origina ...