Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Drive train unit: mm (in) except ratio
Tightening torque specifications
| Note the specified tightening torque is described in the following. “Drive chain related components” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .Reference: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Drive chain replacement
Use the special tool in the following procedures, to cut
and rejoin the drive chain.
Note
when using the special tool, apply a small
quantity of grease to the threaded parts of
the s ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Drive chain related components”
Special tool
...
Other materials:
Diagnostic information and procedures
Starting system symptom diagnosis
Condition
Possible cause
Correction / reference item
Engine does not turn
though the starter motor
runs
Faulty starter clutch.
Replace.
Starter button is not
effective
Run down battery
Repair or replac ...
Starter motor removal and installation
Removal
Turn the ignition switch off and disconnect the
battery (–) lead wire (1).
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the starter motor lead wire (2).
Remove the starter motor (3).
...
Accessory installation
guideline
Install aerodynamic affecting
accessories, such as a fairing,
windshield, backrests, saddlebags,
and travel trunks, as low
as possible, as close to the
motorcycle and as near the
center of gravity as is feasible.
Check that the mounting
brackets and other attachment
hardware are ...