Refer to “balancer shaft disassembly and assembly” .
Balancer shaft
Inspect the balancer shaft for wear or damage. Replace the balancer shaft if there is anything unusual.
Damper
Inspect the dampers for wear and damage, replace them if any defects are found.

Balancer shaft disassembly and assembly
Balancer shaft journal bearing removal and
installationEct sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Drain engine coolant. Refer to “cooling system inspection” in section
0b .
Disconnect the coupler and remove the ect sensor
(1).
Caution
take special care ...
Dtc “c36” (p1764), “c37” (p1765), “c38” (p1766) or “c39” (p1767): secondary
fuel injector circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
Some failure exists in the fuel injector signal in a high
load, high revolution condition.
Injector circuit open or short.
Injector malfunction.
Ecm malfunction.
...